Questions & Answers for: crank marks

Question about 1998 Breeze

1 Answer

...MARKS ON A BREEZE? normally on most cars there is a mark indented in the cam\cams and a matching mark on the block usally a small dot. and the same on the crank on some cranks it also has a degree ...

Ad

Question about 1998 Breeze

1 Answer

marks stamped into the cam and crank gears that need to line up with corresponding marks on the backing plate before you remove the cambelt. If there are no markings, you need to make your own. Rotate

Ad

Question about 1996 Contour

6 Answers

...marks for crank and cam i can not time up my ford escort 1.6 16v zetec. i also can not find the timing marks on the crank because i cant remove the crank pulley, is there any other way of timing the ...

Question about Motor 2002 Elantra

1 Answer

Timing Belt Markings What is the timing belt markings for a 2002 Hyundai Elantra? Mark are on the crank and cam timing gears. Cam gear mark at 12 o"clock crank gear mark lined up with TGC mark on ...

Question about Bilt 5.5hp Self Propelled Mower

1 Answer

marks, position the crank at TDC. Turn the cam so both valves are off their seats. This will be close enough. May be 1 or 2 teeth out from where Brggs intended. Popping through carb at low or cranking

...Crank Timing Marks do you use for TDC on 09 ... Which Crank Timing Marks do you use for tdc on 09 Yamaha 450 yzf as you turn the crank clockwise thr first mark will be the fire mark, the second one ...

...SEE MARK ON CRANK  PULLEY AND MARK ON TIMING COVER AND THAN YOU CAN REMOVE TIMING COVER AND CRANK PULLEY AND SEE MARKS ON TOP CAM AND CRANK GEAR,BEST WAY I CAN TILL YOU ,HOPE IT ...

...marks on hyundai elantra 2009 4 cyl. valve timing, crank pulley T D C mark to mark on timing cover. Cam gear mark to mark on head or block . Ignition timing T D C mark on crank pulley to timing mark ...

marks on crank shaft Try this may be this could help https://big-manuals.com You must set cylinder # 1( firing order) to TDC, on the ignition stroke. You can now mark( with tire chalk) the crank pully

Question about 2004 YZ 450 F

1 Answer

...marks is correct crank and cams So my question is can i still be 180 out on my crank And must i use the screw driver technique to make sure piston nbr one is on its highest point Because the car ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...