Questions & Answers for: crank cam

...cam and crank gears that need to line up with corresponding marks on the backing plate before you remove the cambelt. If there are no markings, you need to make your own. Rotate crank until at TDC ...

...crank and cam to appropiate position start sliding crank gear until cam gear is touching then start to push both at same time make sure your crank key and cam pin are bothin place On many OHV pushrod ...

...cam crank sensor on 2004 Audi A4 The "cam crank" sensor is the "reader" for position and speed of the camshaft. This sensor send informations to Engine Control Unit about camshaft position and speed. ...

...cam shaft crank shaft sensor? is this the same as cam shaft sensor?..2002 TB looses acceleration and stalls out. no each one has its own job, crank sensor is counting crank shaft rpms cam sensor is ...

...cam and crank sensor out of sync (according to scan tool) swapped pcm starts other car fine. timing belt and cam sprocket alignment procedure complete. however left sprocket off maybe 1/2 tooth. ...

...cam or crank sensor. pull the codes from the vehicles computer. if there is a cam or crank sensor code, or if there is a code that says in some different wording "cam sensor signal does not match ...

...crank cam code on again off again...we changed crank sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends ...

...cam and crank angle sensor in 96 N15 I need to find the Cam and Cranks angle sensor on my 1996 Nissan Pulsar N15 1.5L The cam and crank position sensor can be found in the front of the crank on the ...

...crank and cam(s).

The chain markings shift depending on the number of links in the chain and number of teeth on the crank and cam gears, but the number of links (rotational distance) between ...