Questions & Answers for: Yamaha TT-R 125 L no crank

...are making contact with the spark plug up to the starter relay to the battery. I have 2004 ttr 225 crank up 1 time den it quit firing no spark change the spark plug still no spark so wat do I need

DO NOT OVERTIGHTEN THE SCREW. Write this number down, you will need it in case you can't get it to crank. Now, turn the screw out 3 full turns and try to crank it several times. If it will not start,

ttr 125 won't start I was riding this bike a year ago and it ran fine till one day it just quit with me on it I gave up on it and put it away. i recently decided to fix it. i drained the gas and oil ...

I replaced the crank shaft and when I put the engine crankcase halves together there is friction around the crank shaft - it will barely turn. I have replaced the crank shaft with a factory crank and ...

...ttr 125 with a seized conn big bearing. and I would like to know the proper way of splitting the crank too replace it The top end comes off then the left and right side covers, flywheel, clutch

new seals on the sprocket, kickstart and shift shaft when they reassemble. Also have them check the crank bearings for wear. Replace if needed. Re-seating the valves and de-carbon the top end would be

Yamaha ttr230 cranks slow but will not start, I can push start it but can not use the electric start? Sounds to me like your battery is not fully charged. Hook up a charger, wait 6 hours and try again

...piston was fine. The kickstart wont kick over and I cant figure out what is wrong. can you turn the crank shaft over by hand? if not the big end has sized up the piston is normaly the last thing to ...

07 ttr 125 cranks but will not start right up when it does it will not take gas it dies and you have to turn key off and back on before it will start back it will idle for a few seconds and die again ...

I have a 2003 Yamaha ttr125er. The connecting rod bearing was seized up on the crank. I am wondering if I will be able to disassemble the crank and put a new pin and bearing in and reassemble the ...