... timing belt changed need help in alligning the timing marks after changing the timing belt. If the crank is set at TDC what should the cam pulley mark be at 0-1-2-3? The keyway and or the dot on the ...
.005 clearance between crankshaft and timing belt sprocket. 1993 Mazda B2200 2.2L Carb. the size of the crank is .985 outside OD & the timing belt sprocket is .990 inside. It is a remanufactured crank
1992 B2200 Mazda timing instructions Belt broke and I would like to retime the crank with the OHV pulley, How is this done. Thanks RC this site has all the specs ...
...not sure. Would apprecaite any assistance. You need to "bleed" the fuel lines. Loosen injector 1, crank the engine until fuel comes out. Tighten the injector. then repeat for the rest. Do 2 ...
THE ENGINE CUT OFF CRANKED ONE TIME THEN SHUT THE ENGINE CUT OFF CRANKED ONE TIME THEN SHUT OFF AGAIN AND WOULD NOT FIRE. OLD ESTABLISHED GARAGE MECHANIC REPLACED THE COIL DID NOT HELP. TOWED TO HIS ...
Timing mark on crank pulley jumps abruptly about I Installed new timing belt and on completion, I put the timing light on to check the timing, I noticed only one timing mark white, no yellow. Also on ...
My 1992 Mazda B2200 turns over but won t crank but I can roll it of and it cranks every time What causes this? i have the same problem it turns over and its back firing could it be timing I have a 88 ...
...pay, no chancers please !!! Remove the plug from the 1st cylinder, insert a screw-driver, turn the crank by spanner until the screw-driver has moved upwards, and stopped moving. Make a mark on the ...
timing mark on crank pulley doesnt match up with one on cam pulley. back firing thru carb. what do i do? Sounds like the timing chain / belt has slipped. If it has a timing belt, did you replace it at
what is at the bottom and middle of the engine? Sounds like you are describing the location of the Crank Shaft.
Usually answered in minutes!
738 Questions
692 Questions
544 Questions
609 Questions
615 Questions