Question about 2005 PT Cruiser
where is the crank sensor located on 2005 chrysler pt cruiser? Where is the crank sensor located on 2005 chrysler pt cruiser? the crank sensor is located on back right side of engine by were the trans
where is crank sensor located on a 1995 Jeep Grand Cherokee Larado 5.2 liter engine front of the engine near the crank pulley on the crankshaft pulley inside the pulley its a little cylinder which is ...
where is the crank sensor located crank sensor is located near the crank pulley. It should have two wires that go to it.
starter works but will not turn crank If the starter is operational and won't crank then it has to be a battery or wiring issue. The starter may work but it might not be engaging the flywheel teeth. ...
Question about 2006 PT Cruiser
engine light is on and sometimes my car will not crank, sometimes does a little spudder 2 months ago my car would not crank so i got someone to jump my car off and it cranked.. few weeks after that ...
2005 PT Cruiser no crank Drove into garage, running fine. Next day no start. Cranked fine. I got back home today it cranked about 10 revolutions and no crank. Getting power to the ignition switch, I ...
Question about 2001 PT Cruiser
2001 pt cruiser was diving down the road and just shut off will not start If it turns over (cranks) but does not start, it is almost surly a bad crank sensor. Check to see if your tachometer moves ...
Question about 2002 PT Cruiser
ran rough, now cranks, no start,replaced coil,cam and crank sensors. What next??? so, i guess, you never seen a scan tool> you crank engine and you get DTC errors telling you what failed? crank for
Question about 2005 PT Cruiser
why does check engine light come back on after replacing crank sensor code for crank sensor came on replaced sensor but light came back on with crank sensor code The check engine light is still on ...
Question about 2005 PT Cruiser
what would cause a 2000 pt cruiser to turn over but not crank turning over is cranking are you asking why is it cranking but nor starting to get that answer , run the fault codes
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions