Questions & Answers for: Acura no crank

Crank Pully I am working on a 1996 acura tl 2.5 how do I get this crank pully bolt broke loose. You may need to get a special crank pulley tool for Honda/Acura. Or you can use an old crank pulley belt

Will not crank My 1997 Acura 3 2TL will not crank. It sounds as if it is about to crank but will not turn over 1st thing to check would be the battery, have someone jump start you.

it wont srart it just cranks over and over like ite out of gas but its not and there is gar getting the injectures Chk the crank position sensor connection. It's just above the crank pully. make dure ...

1994 acura legend wont crank after you kill it after you crank car and run, it wont crank again if you kill it , seems to be getting fuel Test fuel pressure and voltage at fuel pump.

...turnover unless jumped started. Short answer, your batter is bad. or is disCHARGED: Long.: wont crank? no engine, cranks ,unless the starting system works. unless pushed fast, like my car or i ...

where is thr fuel pump relay located on an 2003 acura rsx post the symptoms. (no start but cranks fine?) what? the relay only closes cranking. and may not if no spark, spark is first, after fuse ...

...the car don't turn on Good morning. cars do not turn on, they have 4 steps. (ottocycle engine cars) cranks, starts and runs, and sustains. (each step can fail) my guess, is yours fails at the crank ...

...trying and, so far, it will start. All other instrument indications seem normal. will or will not crank? if no crank wiggle the gear selector cranking or try cranking in neutral. (fresh contacts ...

Im doing a removal and installion crankshaft position sensor on my 1996 Acura T.L 2.5 my concern is if I remove the crank pully is automatically gonna jump timing. I got to as far that the only thing ...

My acura stopped while driving will crank but woot start and while trying to start it it drags while cranking it Drags while cranking it Have you checked the oil?, it may be very low and hot, which ...