Questions & Answers for: craftsman kicks back

Craftsman 21-inch push mower keeps flipping under mower when backing up, and does not flip back on moving forward again, causing a drag until you lift the rear end of the mower up about 5 inches so it

kicks out of till while tilling it will kick out of till about every few feet. So you have to stop and shove it back into till. Otherwise it seems to work fine. Best thought is readjust the gear ...

...Craftsman Model 944.367301 with Model 143.976600 Tecumseh engine 'kicks back' when trying to start. It almost rips my arm off. What is causing it to kick back? It ran fine when stored away last fall ...

...Craftsman 4 Hp. 15 gallon horizonal air compressor won't kick on. I left it pluged in one day. The next day it would not kick on to refill the tank. Very confusing nothing looks wrong at all. There ...

should kick back bar stop chain when forward or back? I think stop is forward, being designed to stop the chain if your hand slips off the handle. --W/D--

...craftsman 5 gall 1 hp struggles to start but eventually starts, I have only used 3 times oil i is fine If the proplem only happens after the initial start-up with the tank empty, then your back flow ...

...craftsman table saw. Will the motor mount be able to stand the stress of a heavier motor without pulling the arbor out of square with the table? A 1/2-horsepower motor wired for 220 volt operation is ...

craftsman tablesaw (model # 137.218250). i was ripping an 8 ft. 2 x 4 and it started to strain, then the motor kicked off so i pressed the reset button and it came back on. then a few minutes later it

...the pressure of the pump when it kicks off is stuck closed so what is happening is when the compressor kicks back on its under a load and trips braker. #2 your braker is to small for the

craftsman 921.166400 air compressor. The compressor works great until it fills completley, then once if gets low on air it kicks back on but will not run like normal. The motor is quiet and wont build