the trigger stop working the ratchet works but i have play with the air hose on and off to use it. i oil it. sounds as if it needs servicing ,not expensive -----what do you oil it with ? if you dont ...
throttle valve is rotten and tool runs when you plug in the air without pulling trigger there is a neoprene O ring in the trigger area ,that breaks down ,it needs a service by an air tool repairer ,it
Craftsman 1/2 inch impact wrench,not working I have a Craftsman 1/2 inch impact wrench, when I pull the trigger all you hear is air escaping but there is no turning of the shaft? Make sure you have at
...impact wrench wont engage to the socket. I have the same problem, brand new impact wrench, brand new impact sockets, but can't get a socket onto the gun. Leaned on it with all my weight, wiggled, ...
...craftsman 1/2 impact wrench, mine is broken If your local Sears store can't help you, try looking to see if you have a Snap-On, Corn-well, or Matco tool distributor in your area. Many air tools are ...
wont work in remove direction just blows air fill it wit oil hold in triger and flick between forard and reverse should free up the vains inside Squirt in some pnuematic oil where you hook up the hose
impact wrench is not working at all.the air is coming out of the hole at the bottom of wrench next to where the air hose is hooked up. fill down the air pipe wit penatrating oil hold trigger and keep ...
craftsman impact gun model number 875-188992. what size compressor do I need for taking off lug nuts/automotive work? The two most important specs are CFM at 90 psi (that's how fast the compressor
Question about Microtork Torque Wrenches - Model .: 9-44593 Torque Range: 25 250 in./lbs. 1 Drive Size: 3/8"
The ratchet on craftsman microtork torque wrench 44593 does not work 44593 torque wrench ratchet part will not ratchet either way The ratchet pawls have seized and a ratchet rebuild kit is needed.
Question about Microtork Torque Wrenches - Model .: 9-44593 Torque Range: 25 250 in./lbs. 1 Drive Size: 3/8"
...craftsman mower can not remove nut holding fan in place because shaft turns beg borrow or rent an impact wrench place a wrench on nut/bolt and smack it with a hammer, this has the same effect as the ...
Usually answered in minutes!
317 Questions
162 Questions
122 Questions