I need to replace the chuck on a 1/2 Craftsman impact wrench. Well, for sure you can get a replacement chuck from the hardware store or from the Craftsman dealer.
Craftsman 1/2 inch impact wrench,not working I have a Craftsman 1/2 inch impact wrench, when I pull the trigger all you hear is air escaping but there is no turning of the shaft? Make sure you have at
...craftsman 1/2 inch impact wrench, i'm using a 5hp compressor with a 30 gallon tank. I can't even take off the lugnuts on my car with ut lossening them first.I'm not sure if it's my compressor or the ...
...impact tool will take normal sockets for reg duty use but not for wheel lugs and such, they will crack, but if you buy Craftsman, they will replace it. I have only cracked one in thirty years. But I ...
Question about Mechanics Air Tool Kit Impact Wrench/ratchet
...craftsman impact wrench tight?imapact has no pins for sockets to stay on?is there something I need to impact for them to stay on? Make sure the expansion ring is on the end of the impact gun. this ...
Question about C3 19.2 volt Combo Kit, Drill/Driver & Impact Driver
...To get the manual for your Impact driver, I will need the full model number which will look like a XXX.XXXXXX for example. It is found on the side of the tool. I hope this ...
...Craftsman Air Impact Wrench Model No. 875191182? Just put 3-5 drops of air tool oil down the air inlet coupler and then run the gun for 5 seconds. Do this everyday that you run the gun for best ...
I need a manual for a 1/2 drive impact craftsman wrench you can download this from www.searspartsdirect.com
craftsman 3/4 inch impact wrench Model #875185820 need manual Follow this link to the parts list: http://www.searspartsdirect.com/partsdirect/part-model/Craftsman-Parts/Craftsman-Parts/Model-875185820
how do i get more torque out of my craftsman impact gun? buy a better gun the cheap ones dont have any power
Usually answered in minutes!
317 Questions
162 Questions
122 Questions