...working the ratchet works but i have play with the air hose on and off to use it. i oil it. sounds as if it needs servicing ,not expensive -----what do you oil it with ? if you dont have the correct ...
...Craftsman 1/2 inch impact wrench, when I pull the trigger all you hear is air escaping but there is no turning of the shaft? Make sure you have at least 90 pounds of air and if you do you need to oil ...
...air motor is probably shot. Turn the socket a few revolutions by hand, and see if it frees up and starts working. A couple of firm raps on the workbench might help. Otherwise take it apart and see ...
...craftsman 1/2 impact wrench, mine is broken If your local Sears store can't help you, try looking to see if you have a Snap-On, Corn-well, or Matco tool distributor in your area. Many air tools are ...
...Craftsman 3/8" air ratchet (875.199190) just quit working this week and is blowing air out the side of the motor housing. It's only 6 years old, but has been working well for me. I can get it ...
...air fill it wit oil hold in triger and flick between forard and reverse should free up the vains inside Squirt in some pnuematic oil where you hook up the hose, and hook up the hose. Pull the trigger ...
...the hole at the bottom of wrench next to where the air hose is hooked up. fill down the air pipe wit penatrating oil hold trigger and keep movin forward and reverse wen in frees up fill wit airtool ...
Question about 42 in. Deck 19.5hp Lawn Tractor
...craftsman worst design of their mower decks CHEAP!!!!! I had to replace my mandrel on the right side, side where the grass shoots out several times!! Cheap aluminum casting ****, one or more of your ...
...Craftsman 875-188992 is a 1/2" impact wrench. A 1/2" inch impact wrench requires 4-5 CFM @ 90 Psi. But it is always recommended that your air compressor CFM rating is 1.25 times more than of your ...
Question about 42 in. Deck 19.5hp Lawn Tractor
my air ratchet does not work. Head will not turn and air comes out of breathing vents, like it seized up I put some lubrication oil into the air line then made sure that it goes in there by moving the
Usually answered in minutes!
317 Questions
162 Questions
122 Questions