Questions & Answers for: craftsman 16 36cc chainsaw carburetor

...36cc chainsaw--the fuel lines dry roted---i replaced them into the fuel tank--they are two sizes 3/32 and1/16--my saw has a primer bulb--can you plz tell me the routeing order of the fuel ...

craftsman chainsaw runs, but bogs down and/or quits when throttled up. Try turning the "L" needle 1/8 CCW If no better try 3/16 CW. The "L" is primarily smoothness at idle and acceleration. Carburetor

Very hard to start. Will start with autostart and Very hard to start. Will start with autostart and run ok. Spark very weak, Unit is 12 years old and has never broken down. IS it the coil? If where is

...16" craftsman chainsaw fuel line. Problem is one line from tank with two ports on carb and two ports on bulb. There is no diagram to show sequence of connections. The second carburetor port feeds the ...

I have replaced a broken fuel line,it starts with the choke on.As soon as i press the throtle it cuts out.There is no continueous flow of fuel to the carby.Can you help? Fuel filter or carburetor ...

Craftsman chain saw. Won't restart after running for long time. First check is for spark at the plug when it won't fire--it should be blue and snappy with a fresh plug set for 0.020" gap. If not, then

I just replaced the cylinder and piston on a 55 husqvarna. starts and sounds good but does not have the power it should when cutting. I played with the high needle and turned it all the way counter ...

...craftsman 2.3 chainsaw and to adjust carburetor tighten the two air screws to just tight then slacken them to one and a half turns start the engine and adjust the low screw until tick over then open ...

...carburetor setting on a2.3 chainsaw There is no fixed carburetor setting on these engines, just two screws to adjust low-end and high-end operation. Special tool may be required, there are about a ...

...craftsman chain saw 18 will not start The 3 things needed for an engine to run: 1. Compression (Cylinder, Piston, rings, gaskets) 2. Ignition (Spark plug, ignition module/coil) 3. Fuel (Fuel lines, ...