Questions & Answers for: Sears craftsman 16

...Craftsman GDO has a RPM sensor that, if not working correctly, will cause this problem. Either the optical sensor itself is dirty, or more likely, the wheel that is attached to the motor shaft has ...

...Craftsman chain drive garage door opener to operate a 16 ft. aluminum shop door? Richard Barton Email: [email protected] Sears sells RAIL EXTENDER KITS for most of thir GDO'S, mostly for residential ...

Craftsman 1/2 hp opener My 1/2hp opener after reaching full open status will slip back down 12 to 16 inches and then re-activate the motor and go back up. This will repeat 3 or 4 times before finally ...

...16 foot door. when opening or closing the lights on the opener will flicker and the door will stop. I have adjusted the torque setting to the max setting and have also changed the 110 volt outlet it ...

Our Lift-Master Garage Door Opener Model 1265 Gear broke off the sprocket assembly. How hard is it to just replace the part? How is it done? Is it even worth fixing it, or should I just buy a whole ...

craftsman opener, 16 years old, want move, all lights are working power is getting to the unit. sensors are aligned and working, remote or wall switch will not operate. Remove and check the logic ...

I don't have the manual to re-program my keyless entry pad and cannot use it. The previous owner did not keep the manual and on occasion, he comes back and goes into the garage. He is in his mid 80's ...

I got a 12 1/2Hp tacumseh model #143-592012 and the head gasket kelps blowing could it be the timeing and wear can i find diagram of rebuild step by step pitchures Parts Tree Repair Clinic will help ...

Lost household power, garage door opens 12-16 inches, then closes again. Cure? I don't see how your loss of power would cause this. I think you need to check the door springs. One of them could be ...

I have a sears 139.53647srt garage door opener. It is 16 years old. The nylon drive gear finally stripped. Is itt worth replacing the gear, or replace the whole unit. I am mechaically inclined, but ...