Questions & Answers for: cowl Vacuums

My vacuum takes off in drive My vacuum, when it's taken out of neutral and put into drive, literally yanks you off your feet. I can't seem to figure out what is causing this. It's like it's posessed. ...

CHORD STUCK , NOW FIXXED BUT METAL SPRING CAME OUT, WHEN WOUND BACK, HOOW DOES IT ATTATCH TO PLATIC COWL AGAIN

plugged hose on Hoover Windtunnel I have no suction on the floor or carpets and feel the hose is plugged. I have replaced the belt so it's not that. There is no air blowing like there usuaslly ...

Shark V15Z how to change the belt I see no instructions on how to replace the belt. Nor do I see a way to reach it! Well it's actually not so bad once you realize where they hid the screws. Gently ...

...the bottom plate from the vacuum. Instead, think of it as removing the top part (the "hood" or "cowl") from the bottom. LIFT that top off after removing the screws, don't try to pull the ...

...ring to remove the fan/light from the celling. I cannot find it!!! Pls help Mike Boho Remove the cowl at the ceiling by removing the screws in the cowl (very close to the ceiling). Use caution in ...

the grey pre-filter catch broke and we ordered a new one. now we don't know how to install it. I just successfully completed this replacement on a DC33 (the prefilter catch is blue on this model.)

belt replace panasonic vac belt broke Is it an upright?  On mine it's very simple.Unplug vacuum and lay it on floor so that you are looking at the rotating brush.  Remove screws that ...

After using it to clean up construction project, I cleaned the tank, filter and cleared the hose, but I have lost good suction. Check the plug on the side to see if it's loose or missing. There are ...