Questions & Answers for: cover seam

SPH-M620 waterdamage how do you take the covering off the SPH-M620 I got mine open, just take the 4 screws out and work your finger nail or something thin into the seam and work it around till the ...

...cover is a seam; insert something flat in the seam (such as a screw driver blade, covered as to not scratch the finish)and pry the cover downward. This worked for me. ....there are also two screws ...

...sort of thud. One can watch the sound and weld seam location synchronize. My question: Is this covered by a Maytag warranty? The seam gap is nor rusted, by simply gone, with wavy metallic edging ...

...a home machine and a overlock.Al for different tasks. An ovelock machine produces a stitch that covers the raw edge of the seam while cutting excess fabric off. Look at the seams of just about

...be the lamp. check to see if the seams of the lamp that are closest to the underside of the top cover have foil tape covering the seams, if not then this has been known to cause premature

...issue. Take the lamp out and look at the side that is closest to the underside of the of the top cover when installed. There should be foil tape covering the seams on the lamp. If not then heat is ...

i am working on a u5290-900 hover vacuum ,when operating dust leaks out under dirt cup cover. i put a piece of card board on top of cover so extra presure would be applied to the top of cover. this ...

...at middle seamline the thread is pulling apart at the seam where the hot tub cover folds when you open it as long as the cover fabric is not damaged or torn then the seam should be able to be ...

...cover, there are markings indicating various seam allowances. Placing the fabric edge along the specific seam allowance will automatically cut off the required amount of fabric and the serged seam ...

...get the wider cover seam to work. It seams to be a mechanical adjustment... Hello Melanie, could you please tell me the machine make and model along with a little more information about the