Questions & Answers for: Triumph Daytona 600 cost replace stator

30AMP FUSE KEEPS BLOWING WHEN I CONNECT THE BATTERY PLEASE HELP.. I LET MY BATTERY RUN DOWN BY LEAVING THE LIGHTS ON TOO LONG WITHOUT THE ENGINE RUNNING. I CHARGED THE BATTERY UP ALL NIGHT AND WHEN I ...

Ad

...did i blow? I have some bad news, bro! ;-( You blew the ECU (black box / computer box) and it could cost you about 800 bucks - depending on how well you know the dealer. Change the 30amp fuse in the ...

Ad

...less costly and easiest to replace of the two. Additionally replacing the stator and regular in pairs is not a bad idea...unless you happen to purchase a defective one. Sorry don't have better news. ...

have to hold clutch to keep bike from dieing in neutral light comes up, the bike stays into gear. will not engage into neutral. have to stay holding the clutch down to keep bike running, if let go the

Starter just buzzed and power went from display Hi, I went to start my 2003 Daytona 600 and there was a buzzing sound of the starter trying to work and then the power to the display just dissapeared ...

2004 dayton 600--how to replace the steering bearings Hello, i have a 2004 daytona 600 and i need to replace the steering stem bearings; is there a tool i need to pull it our? jerry from fresno,ca yes

I have just replaced the cam chain on my 03 daytona 600 and need the cam bolt torque settings as i done have a manual. Please help! Cam chain tensioner center nut is 28Nm. This is straight from the ...

Question about 2004 Daytona 600

1 Answer

...replace the sensors and it cost $708 in labor, $1600 total. MY GOD!$708 for 2 1/2 hours labor. I will never again purchase a Hyundai. I have few complaints about the vehicle but your labor costs to ...

New stator and regulator flat battery after journey I've just replaced my stator and regulator and I've tested the voltages at the battery and it's showing as charging but ...

Bike overheated have replaced faulty thermostat warning light stays on and will not start, any ideas. Unplug battery and clear code. If this dosent work than the water temp sensor was probably damaged

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...