Questions & Answers for: coolant hose

...coolant, loosen or cut the hose clamps and remove the hoses,replace with new hoses and fill with coolant, then start car and when coolant fills the block add coolant to top off system and replace ...

...COOLANT HOSE TOP WATER PUMP.REMOVE SMALL BOLT THAT HOLDS METAL COOLANT LINE TO WATER PUMP.THIS LINE HAS TO BE MOVE JUST ENOUGH SO YOU CAN REMOVE THROTTLE BODY.ONCE THROTTLE BODY OUT THE WAY YOU CAN ...

coolant hose that runs across the top of engine. starts low from left side firewall and connects to coolant reservoir. it has a leak and coolant is crispy orange bubling out. there are two small hoses

... 4 - Nut (1 Req'd) 5 - Bolt (1 Req'd) 6 - Coolant Recovery Hose 7 - Coolant Return Hose 8 - Coolant Recovery Hose 9 8A808 Degas Bottle A - Tighten to 9-12 Nm (80-106 Lb-In) Hope this helps. ...

...is not clear. My car is Volkswagon Jetta TDI 2000. Does anyone know please give me advice? Thankx COOLANT TEMPERATURE SENSOR THREADS INTO A COOLANT PIPE NEAR THE COOLANT OUTLET.LOOK AT SMALL

hose that runs from coolant tank to rear of engine compartment. Not sure what this hose is attached to, but i can see coolant on outside of hose. what kind of car do you have,and it sounds like one of

...coolant reservoir. There may be one or more hoses connected to the reservoir. Carefully loosen the hose clamps using pliers and slide them back along the hoses. Then, gently pull the hoses off the ...

...hose clamps onto your new coolant hoses. 10. Install new hoses in the same position as your original hoses. 11. Make sure the hoses are fully pushed onto the connection plumbing. 12. Tighten hose ...

...coolant hose, the one at the top inside of radiator, either left or right side. This hose leads in to the manifold going in to the motor, there is 4 bolts attach cooling hose to housing. 1. Drain ...

...hose to the desired length. 4. Attach the new hose to the coolant tank, ensuring that the clamp is tightened properly. 5. Reconnect the negative battery cable and check for any coolant