Questions & Answers for: Pontiac Montana coolan sensor

coolant sensor Where is the low coolant sensor on a 1999 Pontiac Montana located on the radiator According to mitchell on demand there is no low coolant tep sensor, only standard ECT sensor.

ck engine light on code po335 p1336 also location of sensor? getting code po335, p1336 on a 1998 mercury villager 3.0 which is a nissan v-6 engine also where is the sensor located? thank you P0335 and

...coolan resevoir a couple tiomes the sensor is stuck at the bottom if it does not come up may need to replace resevoir Looking at the location, it should be by the thermostat housing.....this is a pic ...

...o2 sensor code P0128 Is code P0128 for the bank 1 O2 sensor on a 2002 Montana? no it isn't ! low coolant defective thermostat defective cooling fan ( staying on too long) faulty ECT sensor and/or ...

my 2000 pontiac montana wont start,it just turns over,both oxygen sensors are shot and the egr valve is stuck closed,which one would be the main problem The EGR will not open at idle or when cold, so ...

were is the heater sensor upstream located on 2001 montana van The heater sensor I think you are talking about it is the upstream oxygen sensor. Sometimes the code reader just says heater sensor ...

I am getting codes p0141 and p0134, and I have replaced the sensor 1 upstream already I failed my Etest and replaced the sensor 1 and upstream.... but I am still getting error code p0141 and p0134 ...

need to know how many sensor. is on my transmission.. 2003 Pontiac Montana v 6 .. can you show me picture where transmission control solenoid goes? There are 12 common sensors and 10 internal sensors.

Where is the location of 02 sensor for bank 1 sensor 1 on a 2001 Pontiac Montana? Where is the location of the O2 sensor for bank 1 sensor 1? Bank 1 sensor 1 means the first oxygen sensor closest to ...

I replaced the front 02 sensor bank 1 this morning and the check eng. lite is still on the code said that it was the one needed replacing the parts store said that it was normal and just needed to put