convergence IC's are bad then you will have access to the convergence menu but the adjustments will have no effect. The fact that you switched the IC's and got the same results shows that the IC's are
Convergence Output IC Failure Corrective Action: Replace the defective Convergence Output IC Part Number 23905094 (STK392-110) using the revised ?T? version IC Part Number 23135090 (STK392-110T). When
Question about AV-48WP74 48" Rear Projection HDTV-Ready Television
menu but did not work. ? You need to replace STK ics which are convergence ICs in your tv You can get from the link below Click this link to get convergence IC It will cost you $20-30 to buy these IC
Question about GB4308 43" Rear Projection EDTV-Ready Television
...to replace convergence IC . YOu can get from the link below . Convergence ICs You need to replace both convergence ICs .It will cost you around $30 . The IC number is STK392-110 . Hope this helps
Question about VS-50705 50" Rear Projection Television
...to replace convergence IC . YOu can get from the link below . Convergence ICs You need to replace both convergence ICs .It will cost you around $30 . The IC number is STK392-110 . Hope this helps
Question about GB5108 51" Rear Projection EDTV-Ready Television
...convergence ic's...still a converg on Apex GB5108 Replaced convergence ic's...still a converg problem this was the second set of ic's..please help did you replace the low ohm feed resistors with the ...
Question about PT-56WXF95 56" Rear Projection Television
had convergence problem; replaced 2 stk392; panasonic pt56wxf95a : had convergence problem; replaced 2 stk392; resulted in bowed image; now tv shuts itself off after high beeping sound, no front ...
...convergence IC goes bad or the fuse going to the convergence ic goes bad. Pico fuses they are called sometimes open up. You may want to open it up and pull the board out and check the solder ...
...double picture and the colors are off. When trying to auto focus the blue lines are wavy. Replace Convergence ICs ,Big black ICs will have PN# on them example STK 392-110 Mats has ICs
convergence IC is already defective. Replacing this convergence IC will solve the problem. In locating this convergence IC you should remove the back cover of your unit but be sure to unplug it before
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions