KP-57WS500 Could you tell me where are the convergence yokes on each tube? those are the small yokes with the rings, there should be a board on each one of the yokes called V boards
Question about KP-57WS510 57" Rear Projection HDTV
...board which has the stk392-560 ic I have a Sony KP 57WS510 rear projection TV which has convergence problem Check the site www.TvRepairKits.com. They have put together a kit for your exact model. The ...
Question about KP-57WS500 57" Rear Projection Television
...sony kp-57ws500 Convergance went out and replaced the stk's in it. Turned on tv after that and heard a pop. Convergance got worse and had no sound just static. Found a convergance and audio board. ...
Question about KP-57WS500 57" Rear Projection Television
...convergence output ICs. If you want to repair it at your own, let me know if you have basic electronics knowledge and little experience to guide you more. I did replace a new IC8001 & IC8002 mounted ...
Question about KP-57WS500 57" Rear Projection Television
...convergence IC's and cracked the D board. Does anyone know how I can fix the D board or where I might be able to buy a new one? And would you know the estimated cost if I have to buy one? go to ...
Question about KP-57WS500 57" Rear Projection Television
...convergence problem. 1. I have the two STK392-560 IC. (I figure I may as well do both of them) 2. How do I get the G-board (brown) out of the TV chassis so I can desolder and resolder the two ...
Question about KP-57WS500 57" Rear Projection Television
...Convergence Board /control. My thoughts is that if you call your local Sony Service Repair Shop and give them the model. They can probably bring out a replacement board and get your 57" back up and ...
Question about KP-57WS500 57" Rear Projection Television
...convergence ic's. I have the board out, know which 2 parts to replace,and have a solder gun in hand. How do I remove the old ic's? Any type of special solder or primer? Ant help would be appreciated. ...
...or 3D pictures.The tv convergence board it have dead 2 STK convergence ICS and some or all it resistors.These parts,must be replaced on the tv convergence board to solved tv picture
Question about KP-57WS500 57" Rear Projection Television
...up? Has A board and also a D board D=A-1300-417-A 1-680-883-13 A=1-685-619-11A A-1401-058-A do not change the board, change the convergence IC's which should be stk392-560's on the D
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions