draw down is to high i have a jrc 1000 radar. It will not power up. it blows a 5 amp fuse but it uses 7.5 amps of power found my fault not i the power cable in, but the interconnect to radar ...
Question about 1000 MKII Radar GPS Receiver
...this very same power cable. Did you find one already? maybe you can tell me wich one of the 7 input connections is the + and - DC power connection so I can connect this thing myself with a home made ...
Question about 1000 MKII Radar GPS Receiver
wire connection from chartplotter to radar dome yes? what about it? it is difficult to guess what you wanjt from this description with no other leads. Generic problem for all JRC GPS Devices Wire ...
JRC 1000 MKII bearing pulse error on receiver screen. Connections to scanner good and scanner turning. How can I determine if the problem is in the receiver? How can I fix it? louonboard Normally the ...
need to know how to connect the 12 v dc power to the unit as I lost my power cable for radar 1000 As you look at the back of the display unit, the power plug has 7 connection posts. Top left is pin 1 ...
Need to connect my J-NAV 500 GPS to my laptop, however, manual doesn't help much regarding which wires to to which pins on the 9 pin "D" connector. Thanks This device if the manual is ...
Question about Plot 500F GPS Receiver
it is a MF/HF transmitter JRC 196GM, when I pressed on TX Tune on the sender it says on display No ATU I have check connection between Display and Antenna unit and it is ok. But it says No ATU on the ...
x band radar is not showing target echoes JRC RADAR pm checked all ok magnetron current also normal If you have checked the magnetron current and it is normal, then the issue with the X band radar not
Usually answered in minutes!
13 Questions
10 Questions
7 Questions
3 Questions
19 Questions