...If you already replaced the brushes you could have a couple problems, the least is the armature commutator needs cleaned and the more expensive is that it needs replaced. This is a problem unless ...
...THEY DON'T LOOK DIRTY. BUT, WHAT SHOULD I CLEAN THEM WITH? It's usually not the brushes but the commutator that needs cleaned. The commutator is the surface the brushes ride on. Go to Walgreens ...
Question about Axxis WFL 2060 Front Load Washer
...your just moving the dust around really. 3) Next using an alcohol damp cloth clean the motor commutator - on this motor it is easily exposed on one of the sides 90 degrees away from, and in ...
Question about Axxis WFL 2060 Front Load Washer
...and the unit doesn't come up to full speed. Did you dress the brushes to the contour of the commutator? You wrap the commutator with fine sandpaper and rotate under the brushes till the curve ...
Question about 18636 03 120V 36V Litheon Hammer Drill Driver W/ 2Large Batteries
Should a commutator fall of my motor after 14 mths of use if my 36volt drill is built tough. It is possible, but normally something else should fail first if the problem was due to heavy loading. If a
...and that didn't help. Please advise. The sparks are most likely coming from the brushes and the commutator. This is an indication of either worn brushes or an armature that is failing and if used ...
new brushes arc you could have a problem with the commutator on the armature being cupped. To remove this you would have to use a commutator stone to clean the surface. I would recommend finding a ...
...to find that the brushes are worn sufficiently for them to not make perfect contact with the commutator at the higher speeds- bouncing and sparking. Now, a word or two of advice from this ...
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
...to find that the brushes are worn sufficiently for them to not make perfect contact with the commutator. Now, a word or two of advice from this old hand- it might be suggested that just the ...
Question about Nexxt 100 Series WFMC1001UC Front Load Washer
...WAS16201UC/28 Washing Machine Three flashing lights wont run. Replacing motor because of damaged commutator. what esle could it be? I reconditioned commutator and replaced brushes. Noticed old ...
Usually answered in minutes!
27 Questions
29 Questions
23 Questions