Questions & Answers for: colorwheel

Question about DP1200x Multimedia Projector

1 Answer

...I put a new bulb in it and no change??? only 3 things cause no light: bad lamp, bad ballast, bad colorwheel, or bad fan. if you feel the fan blowing and the lamp is good, do you hear a high

Ad

Question about LP 530 Multimedia Projector

1 Answer

...at all when I try to start it. No controllamp is lightening. But the lamp seemed to be OK If your colorwheel and fans do not start spinning up, then it's not a lamp issue. The lamp will only strike ...

Ad

Question about HLN507 50" Rear Projection HDTV-Ready Television

1 Answer

colorwheel not spining new 1 doesn't spin either I would like to know about the DMD board AA41-00694E. There is an unused 3 pin socket right next to the 4 pin socket that is used for the colorwheel. ...

Question about 2200MP Multimedia Projector

1 Answer

clicking projector clicking about once a second and screen flickering at same interval the colorwheel needs replacing. the motor bearings are going. if the colorwheel slows down (due to bearings or ...

Question about X1A DLP Slide Projector

1 Answer

High pitch noise from the projector and is not from the fans it's the colorwheel. if you have an infocus x1a, it is a dlp projector and has a colorwheel and dmd chip instead of 3 lcd panels. the ...

Question about X1A DLP Slide Projector

1 Answer

...1n32 show the bulb is bad but when replaced the unit still will not light up. could also be a bad colorwheel or ballast. if you hear a high-pitched whir when you start it up, the colorwheel is ...

Question about LP70+ Multimedia Projector

1 Answer

...to a solid green but nothing lights up from the bulb if you don't hear a high-pitched whir, your colorwheel needs replacing. you can remove the lamp and see the colorwheel inside (colored glass ...

...i thought it was the bulb i replaced the bulb but still no picture or light coming out may be the colorwheel. if the colorwheel doesn't work, the lamp won't light. if the colorwheel and the lamp

Question about HL-P5063W 50" Rear Projection HDTV

1 Answer

... seemed to work and then began to go black again with all 3 lights blinking on the bottom. when the colorwheels start to go bad this is the symtom that shows up. try this listen carefully to the rear ...

Question about ScreenPlay 4805 Multimedia Projector

1 Answer

Infocus Screenplay 4805 No Display, help? I flipped the power switch and the colorwheel starts spinning but stops, this happens 7 times. I replaced the lamp As the colorwheel starts & stops there ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66949 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...