...wont move in any gear.It then grinds when I try to put it in park. It sounds like you broke a Constant Velocity joint (CV Joint). The pop was probably the joint breaking. When you put it in gear it's ...
...Spin the wheel. If it wobbles could be bent wheel. Usually from a hit. Could be simple bent spindle. Usually from a hit. Remove the wheel and brake assembly. There is a short metal spindle that the ...
feel shake in the floor and steering wheel at around 70 mph and a slight turn on the steering wheel you can feel it a little more. what parts could cause this? already had the wheel balances checked. ...
...spin in wheels on slippery roads. if you are stuck in snow or ice or on slippery road surface,try switching the traction control system off. this may allow excess wheel spin to dig the vehicle
...spin the same RPM, power is restored. This system is easier on the brakes. The Emergency brakes are inside the rear Rotor if you have 4 wheel disc brakes. The sensors are in the Drum portion of the ...
...WONT STAY RUNNING ITS LIKE ITS CHOKEING .WHEN I TOOK THE FUSE OUT IT RUNS OK . I DONT UNDERSTAND .CAN I RUN IT WITH THE LIGHT ON Hello, If you have a Traction control button on the dash, turn it off ...
wont go in gears First check transmission fluid. Assuming that it isn't low make sure it is not burnt or bad. It should be a pink to red color, if your not sure but a quart and compare colors. If you ...
Question about 1999 Grand Marquis
...wont accelerate over 40 miles per hour anymore what could be wrong with it If the rear tire was changed, there can be a difference in the tire size that was replaced. If the width is different or the ...
Question about 1999 Grand Marquis
I have a 2010 Mercury Mountaineer front left brake locking up sending signal like if it's spinning out As i understand it your left brake is locking up because the car thinks that wheel is spinning ...
Question about 1999 Grand Marquis
...wheel and tire off, spin the drum if it spins more than 11/2 turns your rear brakes need to be adjusted or change, the drum should fit tight, hope this helps ya if not your wheel bearing are probably ...
Usually answered in minutes!
1,305 Questions
689 Questions
627 Questions
646 Questions
630 Questions