...engine light code 46? Check engine light code 46? the guy that changed my oil said it was a loose bolt behind the engine or drive shaft.. I am not sure about the code number if I remember correctly. ...
...code 12, will show if the diagnostic term is grounded to access codes, it will show any time that is done and the engine not running, all other codes will show after. The 26, 27 codes have to do with ...
...of power) Common Problems: * GM MAP sensors do not commonly fail * Due to erratic engine vacuum, other engine performance problems can cause a code 34 to set Good luck (remember to rate this
...engine is running again the code present might cycle and turn itself off. You might say "if the engine doesn't run shouldn't it have a trouble code?" Sometimes conditions occur that will not ...
...code P0301 For engine misfiring problem check the help links mentioned below. Click the link below to go through the troubleshooting procedure :---- OBD-II Trouble Code P0300? ...
...ENGINE CODE 42 RETURNED RIGHT AWAY. REPLACED IGNITION MODLUE, STILL HAVE CODE 42, REPLACE ECM, STILL CODE 42, CHECKED FOR OPEN OR SHROT IN CKT 423 AND 424, BOTH CHECKED OK On 3.8 engines I have seen ...
...code of engine coolant sensor code. I have had a complete tune up recently. The car will cut off periodically. If you would like to share the codes with us we may be able to help. Its not likely the ...
Question about 2003 LeSabre
...code. Turned off the engine. Restarted the engine and scanned, no code came up. Car ran fine for 10 miles that included 2 times of shutting down the engine. Drove down my drive and stopped to check ...
Question about 2000 Regal LS
...Engine Soon light came on Error code P0440. How to reset Service Engine Soon light after replacing gas cap? Took 2000 Buick Regal LS 3.8 to AutoZone when the Service Engine Soon light came on after ...
Question about 2000 Regal LS
...engine code, service engine soon codes on 2003 buick regal Are you asking how to clear the check engine light? Buy a cheap code reader ( $20 ) plug it in the OBD2 port which has to be no more than 3 ...
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions