Questions & Answers for: Honda CB 700 SC Nighthawk clutch

I need to bleed the clutch on my vt 700 shadow, 1986 model the hydraulic clutch isn't working on my 86 vt700 shadow, my guess is I need to bleed it out. How do I go about doing that? My guess is that ...

1986, VT700C shadow, clutch doesnt work I have been restoring this bike. It sat for 4 months while all metal parts where being chromed and painted. got it back together and started it. The clutch ...

1972 Honda CB750K2. Clutch started slipping at high speed (over 75mph). No noticeable slipping at lower speeds even when punching it through the gears. Also has a slight chatter when sitting in ...

clutch problems ,,Leaver will not operate clutch it will not pull in all the way ...has fluid... checked slave cyl it was stuck cleaned it freed up bleed system and was stiff again and will not ...

handa nighthawk 700 S starter does not ingage motor There is a one way clutch that grabs onto a smooth cylinder on the side of a large gear inside the motor. The smooth barrel surface is damaged or ...

Hi l got a 84 nighthawk 700sc cant get the clutch to bleed l just put in a new kit in the master cylinder. Loosen the banjo bolt on the clutch master cylinder, Put a plastic sheet and a rag under the ...

i am trying to fix the clutch, on my 1987 honda shadow vt700c. replaced master cylinder, and cleaned out the slave cylinder(ton of gunk in it). i bled it out at the slave cylinder but i don't seem

...cool her down then restart, sometimes several times? expensive fix? I think you should check your clutch adjustment. You can take a look at a generic service manual here: http://hrca.onda.com/ Over ...

1884 Honda 6650sc will not disingage wot wont disengauge ? if you mean the clutch then the plates possible stuck ! has the bike been stood a while ? warm the engine up 15 min then find a slope or get ...

...SC Nighthawk hard shifting 1 to 2 gear hard shifting Hi, Anonymous and the usual suspects are: 1. Clutch not adjusted properly. 2. Primary chaincase overfilled with lubricant. 3. Corners wore off ...