Questions & Answers for: click and flame lighter

Question about 1200DFa Dual Fuel (Electric and Gas) Kitchen Range

2 Answers

...flame by lighter, the clicking continues I finally unplugged the stove. I do need to cook dinner soon and would like someone to help me. I'm visiting. My daughter just had a baby and I'm the one ...

Ad

...click noise which is when a spark is delivered to the burner area. Some fridges have a small window or guage which shows if the flame has lit. You may have to look down the chimney. You keep holding ...

Ad

Question about MGR6772 Gemini Gas Kitchen Range

1 Answer

...days now. You do this at your own risk, but try holding a lighter flame next to the igniter gap close to the burner and light the burner manually when the igniter clicks. The heat will dry them

Question about MGR6772 Gemini Gas Kitchen Range

1 Answer

...click and the flame died. This continued to happen for 30 minutes or so. As the towels began to reach a damp-ish state, the igniter glowed (maybe not as brightly) for a brief while and turned off. ...

Question about 153100 Open Flame Patio Heater

1 Answer

...flame. I have also tried a fireplace lighter in the small hole that has a movable cover over it as I have also done in the past, but still no flame. Is it possible that a gas jet? could be plugged? ...

Question about Gold GW399LXU Gas Range

1 Answer

...lighter but it doesn't light with the spark,it could be cleaned by using a safety pin/paper clip and push through the holes where the flame burns all around the burner(s) also steel wool will ...

Question about Gold GW399LXU Gas Range

2 Answers

...come out of flame throws. What else can I check? pressure switch. see if filter is clean Limit switch for heat exchanger open should be closed ,heat up with a lighter til you hear a click then

...new one so it is in direct contact with the pilot light flame, push the pilot light lighter and hold until the pilot light stays lit. May take a few tries and hold on the lighter till it catches. ...

...to the middle so when you put the face plate back on it isn't left inside. Replace the 5 screws. Click it once or twice and a torch flame should appear. That's the condensed version of the link

Question about Gold GW399LXU Gas Range

1 Answer

...click' when you press the button. Gas 'torch' lighters tend to run out of gas more often as the flame burns more fuel at a faster rate to produce the 'Jet' flame. If it isn't lighting properly try ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Kitchen Ranges Experts

Paul Carew

Level 3 Expert

3808 Answers

john h

Level 3 Expert

29494 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66957 Answers

Are you a Kitchen Ranges Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...