sensor from bottom of tank .Have a rag handy and perhaps a small jar to catch the small amount of coolant that will squirt from the hoses. Also remove the coolant from the reservoir and put in a clean
...clean the sensor in the g12 To do the sensor cleaning and or the optical cleaning on that camera, it should only be done by a professional service center. Avoid blowing air into the lens as that not ...
sensor in the camera. It happens on the G12 due to a faulty design. Go to this place www.camerasandparts.com They are very familiar with the problem and it is who we recommend for help with the Canons
G12 furnace blower will not come on. It ignites and the burners come on for about 30 seconds then it shuts off.I have cleaned the flame sensor and changed the filter but no blower. It may be a bad fan
sensor on the front of the camera with your finger of camera strap. 4: Link to download the manual, in case you don't have it. http://support-sg.canon-asia.com/contents/SG/EN/0300419101.html Are there
Question about 2009 Optima
...sensor. Make sure its clean and paint free if you have not already. There is 3 wires, power, ground and signal. The signal wire goes to the instrument cluster via a few connectors. I would go online, ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions