Questions & Answers for: how do i clean the iac

Question about 1997 RL

2 Answers

...of info on this website: http://www.acura-legend.com/vbulletin/f13/diy-iac-cleaning-85010/ Step by step instructions on how to clean the IAC. Not a bad site for Acura owners. Good luck on your

Ad

Clean the IAC valve seating surfaces on throotle bodyto assure proper sealing of the new O-ring and contact of IAC valve flange. INSTALLATION Lubricate the new O-ring with clean engine oil and install

Ad

Question about 2003 Silverado 1500

1 Answer

the IAC at the throttle body and try cleaning it by cleaning the whole throttle body, pay attention to the IAC passageways to clean it. If this does not help you may have to replace the IAC. Good luck

...clean the IAC. If the IAC is to dirty with carbon to clean, your going to have to replace it. Seafoam deep creep can clean the IAC and the rest of the upper intake. Thank you for using fixya and good ...

Question about 2000 DeVille

1 Answer

...clean it. This valve controls the idle speed. After cleaning it turn the ignition on with the engine off. The Iac should move in and out to find the stops. If it does not move you have either bad ...

Question about 2000 Grand Cherokee

1 Answer

clean valve on end of iac. also do not push on iac valve, because it will mess up idle of vehicle. just clean the valve on end to remove carbon build up and dirt. you can use brake cleaner or throttle

Question about 2000 Grand Cherokee

3 Answers

...IAC valves do get dirty and will stick either open or closed. You can take that assembly off and clean it with either carb and choke cleaner or brake part cleaner both are quick dry and leave no ...

Question about 2004 Colorado

1 Answer

...control (IAC) it may have carbon build up in it. make sure pcv valve is working properly. you can use carb cleaner to clean IAC valve. after IAC is removed, clean at throttle body side also.

...IAC). Clean where the plate sits and on the back of it/them. You have to remove the IAC to clean it. Brake clean and a toothbrush works fine. If it still is high. Diagnostics need done for the IAC. ...

Question about 1993 Topaz

2 Answers

IAC sensor and clean it with a clean flannel. The electrical failures of the IAC valve may be due to one or both windings of the stepper motor being short-circuited or opened, leaving the IAC valve in

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...