Questions & Answers for: Dodge Grand Caravan chrysler limp mode reset

Chrysler Voyager with 3.3 litre engine and 4 speed auto, and the auto is 'playing' up. Reverse engages, but when you use throttle in reverse it just seems to be slipping and will only take the vehicle

I have no other problem, fluid level is good. Trans has one into limp mode, This was programmed into the PCM to get folks home or to the dealer for service. Something is wrong with trans. Any codes??

...the problem you have is the van only has 2nd gear. This is limp mode. You need to have the Transmission control module scanned for codes. You likely have a bad speed sensor. Does the speedometer

...limp mode because there a problem in the trasmission you need to get your van pass on a scanner to see the code it could simply be the input or output sensor there sensor on the transmission and to ...

...limp home mode but still shifts hard. Could it be the pcm,tcm,or soleinoid pack or something else? I have changed the input and output speed sensors and tried to clean all conections with electrical ...

...limp mode due to the speed sensor code (limp mode means the trans starts out in second gear in order to at least get to a mechanic).  The first thing I would do is have these codes cleared as ...

po725 stays in limp mode Check and clean connection at Crankshaft position sensor as a start. May be defective but try cleaning first.

...limp mode limp mode is a system built in the ecm or pcm that will allow your vehicle to drive at a slower speed when the ecm or pcm detects a problem so that you can stop at a safe location or drive ...

...limp mode. Now no engine light but still won't shift. Start it a day later and everything works fine?? Check the "Pressure Switch" as it sounds like the one on that transmission is going bad. I had a ...

...limp mode hello everyone! i need some help here. i have a 2002 dodge grand caravan 3.3 that is stuck in limp mode. here is the back story on it: in the winter the van went dead, it was jump started ...