...sure the locating pin is in the guide hole on the top side of the crossmember right over the "pork chop". If your tool does not have this locating pin, be sure to attach the tool squarely on the top ...
95 Ford Windstar brake or ABS chatter Bad week--first my brakes crunched ("chop-chop-chop-CRUNCH"), then transmission went. Replaced the transmission and front brakes. Also adjusted back wheel ...
i have a humming noise coming from front left wheel while driving, i know its not the tires , just had front end alignement if the tires are not chopped and cupped, from an alignment issue, then my ...
...with a lot of wires running to it. Take it off the manifold, and with a small brass brush and a chop stick to poke down in the ports clean out the EGR ports. Reinstall and see if the code goes ...
Question about 2001 Windstar
I have 2001 ford windstar sport that chops off at highway speed. Changed cam and crank sensor with no difference. Any advice? What about MAF sensor if the motor does not know how much air its getting ...
cam senceor where it If you look in front of the engine (pass. side of car) just above the water pump, you will see what looks like a chopped off distributor with two or three wires coming out of it. ...
when driving makes loud humming sound in front end Usually when this occurs the tires are very chopped up or there is a bad wheel bearing.
im converting a 91 f150 to a 94 f150 and i badly need wiring diag for both vechicles . the harness was chopped lol . You can get both wire harness diagrams from faxonautoliterature.com. These are Ford
noise in front whels A humming/growling noise could be wheel bearings. Check the ware on the tires too as unusually worn tires (chopped) could cause a rumbling noise going down the road. Hope this ...
How do I get a replacement key for a 1997 Ford F 150 when I have lost the key ford chop garage
Usually answered in minutes!
3,749 Questions
2,998 Questions
2,612 Questions
2,348 Questions
2,636 Questions