1980 ford f100 choke no voltage i am not getting voltage to the choke so the truck wont start right up how do i check and/or fix this problem a wire diagram would help greatly I have somewhat of the ...
Question about Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine
choke hook up to on a troy built tiller? The choke (butterfly valve inside the carburetor) is attached to a lever on the side of the carburetor. This lever opens and closes the butterfly valve. Attach
Question about Bilt, Tuffy, Rear - Tine Tiller, 4.0 Tecumseh Engine
...choke returns to idle it stalls. I have a honda model GCV190-AS3A Mower engine. Is there a step by step setup guide ? How can i repair it? Thaks In Advance Dom Sounds like you dont have the run ...
...choke stove for an 1983 ford f150 5.0. I took the stock manifolds off and i'm putting headers on and i need to hook up everything like it would be stock. It seems no one can find this part I've tried ...
I have a Ryobi HT26.In the back of the primer under before the gas tank is a choke lever and throttle lever.My choke lever is connected to nothing in the back or front of mygas diaphram.Does'nt it ...
...hook up manual choke on 1405 elderblock The power lead (12 volts) goes to the "S" terminal (small wire) of the Alternator, "S" is for Stator, then if the choke has a ground terminal it hooks to ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...hook up to? Thanks Chuck in advance. The throttle wire plasric end sits through the back of the crancase and into the square cut a way into the tank back handle, the hooked wire end drops into the ...
Question about 1979 Bronco
...hook up my choke to the washer motor i ran a 14 g wire from the one that came out of the firewall to the choke and blew the fuse and found that the fuse should be 20 and the one that blew was 15 what ...
...unit --generic answer--hook up fuel -prime unit with ignition system some have you push key in before starting to prime or choke --lift throttle to choke -or have auto choke and turn key to ...
Question about 1979 Bronco
way to convert to manual Disconnect the auto choke assembly and hook up some sort of mechanism to manually open and/or close the choke. Spring load the choke so that the default position is fully open
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions