...choke should not require holding out check cable adjustment unless the machine is in gear with the side stand down you should not need to hold the clutch in unless your stand switch is faulty try the ...
Question about 20 Hp 42" Deck Lawn Tractor
...276680 died and wont start got fuelt o carb and spark Mine did same thing, need to manually adjust choke. If you raise hood and adjust your throttle you will see that when you press up to choke that ...
Question about 21 hp 42 in. Deck Yard Tractor - CA Model
tractor only runs with choke on , stalls when you take choke off Hi there, The choke cable needs adjusting. There is a strap holding the sleeve on the carb. loosen it and adjust the choke position, ...
...choke cable may be detached or far out of adjustment. With a helper see if you can watch the choke cable move the choke lever on the carbs when you move the choke lever to full choke. Cables do break ...
...adjustment screws and recheck performance...If choke stays on to long after warm up (idles fast) adjust the choke toward open or lean position. Try no more than 2 notches either way between ...
Question about 21 hp 42 in. Deck Yard Tractor - CA Model
choke adjustment, so keep in mind that this will also change how long the choke stays on as the engine warms up. 2. You can also set the high speed idle (a ***** just above the warm idle *****, on the
...adjustment or rebuilt most likely The choke cable has an adjustment on it... it may not be pulling the plunger up enough to work properly.. a good cleaning/setting by a professional should fix
...Choke is an adjustment to air intake to adjust fuel/air mixture and is heat related. Do not fully open choke as soon as it starts. Gradually open as the trimmer warms up. If a happy medium can not be ...
Question about 2005 Big Bear 400 4x4
How do I adjust the idle and how do I adjust the choke cable? Hi Jim: Make, Model Year Carb? Probably yes since you mention choke - Idle is adjusted by screwing the throttle stop screw in or out. - ...
Question about 2005 Big Bear 400 4x4
...choke in it kills the saw an quits the model of my saw is 358. Not sure of the other numbers I've adjusted the high an low jet settings an throttle screw adjustment an made no difference is it an ...
Usually answered in minutes!
652 Questions
681 Questions
595 Questions
586 Questions
644 Questions