Questions & Answers for: chevy u joint

Question about 2001 Blazer

Repalce ball joints 01' Chevy Blazer 4WD

Chevy Blazer 4WD. I had everything loose and could even move the ball joint around but could not get it out. Do i have to take the upper ball joint loose or can i just loosen the half-shaft and get it

Question about 1998 Camry

1 Answer

Ball joints goin out on a 89 chevy s10 blazer

ball joints goin out on a 89 chevy s10 blazer ball joints going out to much on a 89 chevy s10 blazer how The ball joints are going to be hard to due if you due not have an arbor press in your garage. ...

Question about 1998 Camry

1 Answer

Replaced the U joints on my 2001 Chevy s-10. One of the U-joints had a coupling when I removed it. However, the parts store said there is no call for a U joint with coupling that attaches to the rear

...joint with coupling that attaches to the rear I replaced the U joints on my 2001 Chevy s-10. One of the U-joints had a coupling when I removed it. However, the parts store said there is no call for a ...

Question about 1994 K1500

1 Answer

Steering loose on 1994 chevy 4x4

...chevy 4x4 ball joints and tie rods look and seem good check the idler arm and pitman arms a quik and dirty way to check for play in the front end is to have an assistant rock the steering wheel back ...

Question about 1994 Suburban

1 Answer

How to replace upper/lower ball joints

...chevy suburban YOU NEED SOME TOOLS LIKE 1/8 1/2 DRILL BITS.YOU NEED A PUNCH.YOU NEED A BALL JOINT SEPERATOR.YOU NEED BALL JOINT PRESS TOOL TO PRESS OUT BALL JOINT AND PRESS IN NEW BALL JOINT.YOU WILL ...

Question about 1995 Silverado 2500

2 Answers

I have a '95 Chevy Silverado 2500 7.4L 2wd, I seem to be going through ball joints rather quickly. I replace them at least once a year. Is this something that is problematic with this model or is

...joint will fall apart. Pickle fork is a waste of money. Don't let anyone tell you different. I would not any of my guys use them at my shop. They are scrap iron. I have the lower rivets to drill on ...

Question about 1995 Silverado 2500

1 Answer

93 chevy g20 have speedometer cable

...joint anyone have any clue. and does the 93 chevy g20 have a speedometer cable and where is it located The speedometer cable should not have anything to do with changing the ball joint. it goes ...

Question about Chevy Silverado Extended Cab

0 Answer

My abs light stays on after putting new ball joints on on my 2000 chevy silverado

My abs light stays on after putting new ball joints on on my 2000 chevy silverado Abs light stays on Probably the ABS sensor(s) were damaged during the ball joint replacement.

Question about Chevy Silverado Extended Cab

1 Answer

Chevy Suburban I can’t free lower ball joint from steering knuckle any suggestions ( BROKE : Ball joint separator , tie rode separator) How do I free driver side lower ball joint from steering knuckle

Question about Chevy Silverado Extended Cab

1 Answer

Chevy Equinox. Tools needed to change ball joint please?

Chevy Equinox. Tools needed to change ball joint please? Socket Set, Pliers and a ball joint splitter (the are held on a tapered shaft). Somewhere like AutoZone probably hire them out. Videos in the ...