Questions & Answers for: chevrolet corvette headlight door problems

...corvette/dash2.htm#Warning Lights, Gages and Messages thnx. Hi Do you have the repair manual for this car ? It should have the circuit diagram of the whole car. Neways, the problem seems to be with ...

the headlight doors on my 1998 vette will not open if they both stoped workin at the same time i'd start by checking all the vacuum lines going to the headlights they are motorized. there is a little ...

corvette, headlight goes down and motor continue to run Check the sensors that tell the relay to shut off when the lights close down all the way. This is a fairly common problem especially if this has

...a brass one in the problem light on my 2000 Corvette. sounds like you need to replace the relay for that headlight door, also make sure all the connectors are clean and tight, check for water ...

...corvette I have the same problem. I am not interested in repairing, or re-installing a new pop up head light system to my vette. I just want them outta my 1997 vette. I am going to install new FIXED ...

...corvette when i close my door? check your dimmer switch on the headlight control it should have a knob you can turn, turn it till it clicks and stops then turn the other way till it clicks again and ...

headlight problem with my 2000 Corvette. Sometimes when I start the car both headlights pop up and turn on and the switch will not turn them off. I have to turn the engine off and turn the light swith

...corvette coupe stays on all the time make sure the interior light switch is turned off so they only come on when the door is opened(this happens alot),the next thing is it could be a door switch that ...

...headlight doors will not open or close head light work I have the same problem I replace the Gear in in both or my light go to E bay and researcher repair kit for corvette light , if You to know how ...

corvette problems headlight doors sometimes dont open sometimes do, lights come on but not by headlight switch. switch has no effect You have major wiring problems or bad switches. I would replace the