...paper path. Turn the printer off and open the top cover. Make sure that paper is not jammed in the printer. Lift the right black rectangular paper sensor (located in the middle of the printer just ...
Question about OfficeJet D135 All-In-One InkJet Printer
path. Facing the front of the machine, lift the cover up and toward you, then disconnect a cable attached to a board on the rear of the operation panel. To access the document feed mechanism, remove a
path. Facing the front of the machine, lift the cover up and toward you, then disconnect a cable attached to a board on the rear of the operation panel. To access the document feed mechanism, remove a
paper feed path, and, after extracting a very small loose piece of paper, checked to make sure there are no obstructions, pieces of paper, or anything to keep a sheet of paper from passing all the way
path. ? Check the drum ground. The laser scanner cable assembly is defective. The page length and margins are not set correctly for the paper size. Verify that the ribbon connector at J1307 of the
Question about Color LaserJet 4550 Printer
...path. 18 Check the drum ground. 19. The laser scanner cable assembly is defective . 20 The page length and margins are not set correctly for the paper size. Verify that the ribbon connector at J1307 ...
paper path Reset the printer and clear the paper path of any paper that may be jammed in it, using the following instructions: 1. Leave the printer turned on and disconnect the power cable and the USB
...paper path has a sensor that is mounted opposite the size is adjustment slide on the paper tray. Typically a small opto-sensor it can be blocked with dust. The best solution is to disassemble the ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions