...point check the coil of the contactor for 24V~ . If there is voltage at entry point and voltage at coil and no voltage at exit point ***Replace Contactor*** 4. If there is no voltage at coil Check ...
...point plate on, check the spark advancer for proper function. Twist the point cam and it should snap back to the correct original location. If not MARK the relationship between the point cam and the ...
...check the point gap and condition of the points. With the points open, measure the movable side for battery voltage (12.6 volts?) When the points close, there should be no voltage at the movable arm ...
no spark bikes ben in shed 5 years tried starting it but have no spark cleand plugs and points and checked wires if you cleaned and set the gap on your points check and make sure the you are getting ...
...point plate should be grounded. Check for any oil or grease in between the points contacts, the contacts have to be dry. Last check for the rotor shaft to be turning, as you turn the engine the rotor ...
...should be a stepped fibre washer between the wire and the point base as there can be no contact until the power gets to the movable point. Check that the movable point is not touching the point ...
point pivot is broken or missing. Check that the coil is ok and that the run circuit resistor is ok most of these checks can be carried out by turning on the ignition key and removing the ht lead from
78 sportster with no spark. checked coil, wires leading to and from, new spark plugs, wires, points, condenser. You are missing something here. If you have check all above then you must have a spark. ...
Question about AQV36JA Classic 36000 BTU Single Zone Ductless Heat Pump Mini Split Air Conditioner System
...keep on flashing? Operation = Flashing Display Timer = Yes Turbo = LED Display = E1 Explanation and Checking points = Indoor unit room thermistor error - Open or Closed Circuit - Check and replace if ...
Question about AQV36JA Classic 36000 BTU Single Zone Ductless Heat Pump Mini Split Air Conditioner System
...check if coil is grounding by sorting the negative (1). Also sheck for spark at this point by removing HT lead from distributor and holding en close to ground point (engine or body) but not touching. ...
Usually answered in minutes!
2,517 Questions
1,056 Questions
713 Questions
416 Questions
354 Questions