check gauges light comes on but gauges are all mycheck gauges light comes on but gauges are all fine that could be anything from low coolant to low washer fluid or brake fluid check all your fluids if
...check gauges light means exactly that, look at your gauges, there is something wrong, look all the gauges when the engine is running, usually the temp gauge is to high, is the vehicle overheating, is ...
...check the gauge fuse, if the rest of your gauges are working this usually means the fuse for all gauges including temp, oil, fuel are ok. Next you'll have to locate the sending unit wires at the fuel ...
...Check Gauges" light is on, the light means pretty much whay it says...CHECK GAUGES! One or more of your gauges is/are reading outside of normal operating range. You could be having an overheating ...
Question about 2003 Grand Cherokee
check gauges signal , temp gauge stop work, when I acelerate everything goes normal again this mornin when I start my truck check gauges appear in the dash and temp gauge go down,but ,when I acelerate
...check out ok. If all voltages checked ok, then most probably its faulty instrument cluster board on which gauges are connected. Yes if cluster circuit board looks ok, then also it can be faulty. ...
Check gauges light on all the time. I replaced radiator cap and topped up coolant . Also checked and topped up engine oil, power steering fluid, brake fluid . All gauges show normal reading but the ...
...gauges fuse? Check for 12 volts at the orange wire on the fuel gauge. If missing check instrument fuse and associated wiring. If present do the following checks: 1. Remove gauge. Ground Y/W wire of ...
Question about 2001 FXDWG Dyna Wide Glide
mazda b2200 fuel guage not work sending unit new Check the wires going to the instrument cluster, and check the wires from the sending unit. Possibly a corroded or damaged wire/connector Pull apart ...
Question about 2001 FXDWG Dyna Wide Glide
gauges, check the connector near the fuel tank. There should be two cables going to the tank, try to bridge them and see if there is response from the gauge. If the gauge responds, then the problem is
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
