...Check each lamp in fuser. (lamp is good if you get continuity) (lamp is bad if open) 2) Check the thermostat. (thermal control device) (triggers if unit gets too hot) 3) Also check thermistor ...
...Broken fuser heater lamp wire. Check for continuity. If none, replace the fuser heater lamp (See page P.1-5-15). You need to replace the fuser. 6000 means fuser error 0098269 is your page ...
Check fuser for bearings, fuser drive, fuser roller cleaner or worn rollers. Check exit sensor, is it out of place, is the actuator worn out, is the paper curling and coming off of the paper too early
...Check the fuser. Beside the fuser, also check the gears that connects to the fuser. You may put some grease to lubricate the gears. Please note that fuser for P3005 is not consumer installable part. ...
...fuser service check? on page 2-91. Error Code 923.xx, 924.xx, and 925.xx may display for a hot fuser failure. CAUTION: .The fuser may be hot, use caution before removing or servicing. CAUTION: There ...
...measures: Check and reinstall if necessary Causes: - Broken fuser heater lamp wire. Check procedures/corrective measures:: - Check for continuity. If none, replace the fuser heater ...
fuser. Check the connector J5013 between the fuser and the printer. Replace it if damaged. 2. Short in the sub thermistor. Turn the printer off and remove the fuser. Measure the resistance between the
Question about WorkCenter 4150 Black and White Copier
fuser assembly. Check that the thermistors, PL 10.25 Item 9 are clean and in good contact with the fuser heat roller. Check the wiring to the thermistors. Install new components as necessary, PL 10.25
Question about lj ent 600 m602n 52ppm ntwk mono ce991abgj
...back in Fuser is not being recognized by machine . New Fuser , New HVPS. No loose connections checked twice, is it possible I have a failed HVPS? Or Fuser has failed ? Is there a sensor that ...
Question about lj ent 600 m602n 52ppm ntwk mono ce991abgj
Check the fuser sensor: Make sure that the fuser sensor is properly connected and that it is not damaged or malfunctioning. Check the software: Make sure that the software is up-to-date and that there
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions