...Check engine light is only on while the starter is spinning. Don't want to buy a SMEC unless I know for sure it is bad. HELP! Go to the junk yard and see if they will let you test it with a similar ...
...Check for continuity between the ground circuit wire at the distributor connector and ground. If continuity is not present, repair the harness as necessary. While observing the voltmeter, crank the ...
...crank sensor . You really need to start the truck and reach behind the motor and start shaking and pulling on the wiring harness.The wires themselves to the sensor may be bad. if that doent work try ...
but will crank back up but got to give it gas. i have replaced the fuel filter,air flow falve,check all vaccum lines and can not figure it out. Check TPS (Throttle Position Sensor) could have gone bad
...check for spark out of the plug wires at the plugs. Pull a wire and insert a #2 phillips screwdriver into it, hol the shaft of the screwdriver aprox 1/8"(no more) from the exaust manifold and observe ...
crank sensor has also been replaced. most of the rest of the sensors have been replaced in the last few month. also replaced the distributor and all the **** that goes with that. Sounds very much like
...crank shaft sensor , spark plugs and wires were replaced. I don’t know a lot about this no fireing problem hopefully someone can help me fix this problem so I don’t send it in and spend a lot more ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions