power steering pump squeals and the belt is loose. i am going to tighten the belt and hope that solves the problem. i also checked the fluid and it is ok. if this doesn't stop the noise then i suppose
...on!!! 1994 buick skylark with 2.3L dont know what to do ??!!?? plz help Thank You.. could be the temp sensor. i had the same problem with my grandparents car after they had the water pump
...WRENCH ON THE PULLEY NUT,RELEASE THE TENSION TO REMOVE THE BELT. (YOU MAY HAVE TO MOVE THINGS OUT OF YOUR WAY TO GET TO THE TENSIONER) You have to take off the power steering pump to get to
...Power Steering Fluid I need to change the power steering fluid in my 1997 Buick Skylark 3.1L V6 and in the Haynes Repair Manual it doesn't mention it. The fluid is nearly black not the amber that the ...
...pump in 1994 buick skylark DEPENDS ON ENGINE , BUT MOST ARE PRETTY STRAIGHT FOWARD EVCEPT FOR THE MOTORMOUNT THATS IN YOUR WAY IN REMOVING THE BELT IT HAS A BUSHING AT THE BOTTOM WHEN YOU REMOVE THE ...
1994 Buick skylark. we have tried two different keys and the ignition switch will not budge. try pulling the steering wheel to to one side or the other while turning the key some times the collum lock
Where is the thermostat located at on a 1994 Buick Skylark Quad 4 thermostat on the quad 4 engine is on the right hand rear side of the engine near water pump. hope this helps
How to change fuel pump and not assembly http://www.ehow.com/how_7613769_install-buick-rivieras-fuel-pump.html
...power steering pump? Remove the drive belt. Disconnect the two hoses (one pressure, one return) from the pump... catching the contents of the pump's reservoir with a pan under the vehicle. Crowfoot ...
Question about 1994 Skylark
steering column ! check for battery voltage at the Orange wire in connector # 1 , that is voltage supply to the headlamp switch ! Power going in an no power coming out with the switch in the headlamps
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions