Questions & Answers for: Chrysler Concorde changing the fuse

i change fuses, radio still not working, does the car have to be on to change fuses? There are 2 (or 3) fuses for your radio. One on the Constant (memory retention) and one for the ignition (on and ...

94 concorde as stated earlier car wont start. changed fuel pump it pumps when i jumper wired the fuel relay. changed cam sensor changed knock sensor changed coil pack.when turning key car cranks over ...

my 98 concorde wont blow heat on defrost, only on the vents my 98 concorde will only blow heat through the dash vents on high. it wont go on defrost or anything. if you change the fan speed it just ...

cigarette lighter fuse blows out too often, which one is it I changed all the 20A fuses, but cannot figure out which one it is beyond this I use the lighter to power my satelite radio its not a 20 amp

i have a 2000 chrysler concorde transmission takes off in second gear and stays in that gear will not change doesnt slip but wont change Does you speedometer work? shift solinoids need to be changed. ...

bad cigerate lighter in a 1998 chrsler concorde Most of the time it is a bad fuse that needs to be replaced. You need to try to replace the fuse before you do anything else. If you change the fuse and

Car will not change gears, rpm goes high Went under the hood to look at fuses for brake lights and moved some fuses around and now my car will not change gears when I take off, the Rpm staya high. I ...

wipers stopped working, changed motor, control arm and fuses, wipers still not working, changed to other fuses and now car wont go past first gear, before i change the fuse it was driving fine now my ...

I have a 1998 concorde changed the fans both hoses checked fuses there ok but the fans dont turn on think maybe the coolant sensor temp switch on the radiator controls the fans. its screwed into the ...

fuse s under hood keeps blowing. It is the inj/coil fuse changed engine now keeps blowing fuse when you crank it. starter cranks, fuel pumps runs. no fire or fuel to cylinders Try jumping the starter ...