Questions & Answers for: how to change iac

Question about 1994 Lumina APV

1 Answer

...IAC manualy with no change. Checked wiring to computer, Power and grounds and to IAC motor. Also tryed new ECM. All sensor readings with in spec. Does anyone ave any ideas? OBD does not control, an ...

Ad

Question about 2001 F250 Super Duty Super Cab

5 Answers

2001 FORD F250 5.4L HIGH IDLE PROBLEMS.CHANGED IAC AND STILL THE SAME High idle Changed IAC still the same, shown on scanner IAC 50-60 %, if it set to 40% the Idle is ok. What cause the PCM to set IAC

Ad

Question about 2001 F250 Super Duty Super Cab

1 Answer

iac. Listen for a change in the idle of the engine. then reconnect the plug to the iac valve and turn on the a/c and listen for the engine idle speed to change. If not then replace the iac valve. Hope

Question about 2002 Grand Marquis

1 Answer

2002 Mercury Grand Marquis. Initially car would not hold an idle. It would stall after starting. Changed the IAC. Replacement component started making a "howling" sound while engine was running, ...

Question about 2000 Sable

1 Answer

...speed that is greater than the desired rpm.IAC circuit short to GND Damaged IAC valve Disconnect IAC valve and look for little or no change in engine rpm as an indication of a stuck or damaged

Question about 2000 Sable

1 Answer

...the IAC system failed. There is an 3 pin from the IAC. Remove it from IAC when your engine is idling.Check whether there is an idle speed change? IF it does not fluctuate then your IAC has gone

Question about 1999 Taurus

1 Answer

...IAC valve and look for no change in engine rpm as an indication of a stuck or damaged valve P1131 - Lack of HO2S-11 Switch, Sensor Indicates Lean A HEGO sensor indicating lean at the end of a test is ...

...change iac tps map sensors still idling high rpm is about 1400 exhaust getting red hot sucking air at back of throtlle body code po505 i have changed iac tps map sensors and still rpm at abuot 1400 ...

...inlet is plugged Damaged IAC solenoid Damaged PCM The IAC solenoid resistance is from 6 to 13 ohms Disconnect IAC valve and look for no change in engine rpm as an indication of a stuck or damaged ...

...and it is a manual transmission,scary sometimes. What makes you think the IAC is the problem? Highly unusual to change this valve as much as you have in the time fame indicated. What are the

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...