door lock assembly. It can be purchased on ebay or at an authorized dealer. I had the same problem and changing the door lock assembly solved the problem. One thing to notice is the orientation of the
...Change the door latch assembly first.This will most likely be the answer.Its a electrical locking catch that the door locks into.The error code is very accurate on this model so change the DOOR LATCH ...
Question about GLTF2940ES Front Load Washer
...door lock keeps clicking when open or closed and panel flashes partial digits ok... the short story: door lock keep clicking trying to catch the door loop over and over and over and the 3 digit ...
...change the door lock.. Machine won't spin and was giving E47 error code. Checked resistance on PTC heater and it was normal (about 1500 ohms). Replaced front door lock assembly and it fixed the ...
Question about Affinity ATF7000ES Front Load Washer
...same code persists. Could it be the door lock/switch with good voltage? check to see if the door stike is not broken on door if good and you have changed door lock asm you have a bad control ...
Question about 30" Self-Cleaning Slide-In Electric Range - Black
...door lock bracket back and forth but still no change. Oven is 4 years old. I have a similar problem with my electric Frigidaire convection oven, which flashes ERR F9 and beeps after finishing a ...
that comes down from the tub and leads into the drain pump.there is a plastic coin trap in there that may need to be cleaned. the door lock may also need to be changed e10 is just a general error code
Question about Affinity ATF7000E Front Load Washer
...change), checked the stricker (fine), removed outer seal and disconnected and reattached (I also received an E41 error when unattached) the door latch sensor/assembly. I'm trying to figure out if ...
Question about ATF6000ES Front Load Washer
...change it? We have an E41 error code, already replaced the door lock mechanism. Washer will work if we leave it unplugged over night and then goes back to the E41. I can not find anywhere that says ...
...door not locked. This is not my case. When the problem is with the belt, it should not spin in diagnostic mode. It does spin in my case. When the problem is the control board, you get an error code ...
Usually answered in minutes!
2,660 Questions
1,146 Questions
974 Questions
650 Questions
256 Questions