change the rear brakes got eveything off but in the new pads but it's not fitting over the roda did you depress the brake caliper piston all the way in you will have to put it back together, With your
...brakes, traction control are all lit up and dinging when the car starts. I hooked the sensor back up that was located on rotor, what am i missing? recheck the sensor most likely not properly hook up ...
...change the brake pads on a 2005 grand prix pontiac remove the caliper, by removing the two holding bolts, then use a old brake pad against the pistons and a c clamp and push piston all the way in, ...
changed back brake pads and the brake light will not go out make sure fluid is full. You may have to tap on the resovoir if the switch is stuck because fluid was low.
...change rear brakes REMOVE CALIPIER MOUNTING BOLTS ,THERE IS A CALIPER TOOL THAT TURNS THE CAPLIER PISTON IN FLUSH SO YOU CAN INSTALL NEW BRAKE PADS hey may be you try already the C clamps and dont ...
...back brake on drivers side smoking. it does not need new brakes. Does now ! change your caliper, rotor and pads, because pads and rotor have overheated from caliper setting up and not floating ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions