Questions & Answers for: chainsaw revs high dies

revs fine. It will cut through 16" wood but it must not go over 3/4 throtle when it will die. It is about 0 to -15 air temp any ideas? Try turning the high idle screw out 1/8 to 1/4 turn refer to your

chainsaw. It has a choke pulled out all the way to start it then runs/revs to high. when he pushes the choke in it dies. what needs to be fixed inside? check ur governor spring or linkage---adjust air

...high speed screw until you get maximum revs..then,turn screw 1/4 turn out.that makes it slightly richer,cooling the plug with droplets of petrol.you dont want it lean.if it wont rev fully,check the ...

chainsaw high revs, floods, and dies when i let off the choke its been standing all summer ,,,yes? you have a carb fault strip the carb and fit a new repair kit in it, also clean out all the carb jets

chainsaw wont throttle up dies out;cleaned out carb. relaced fuel lines . give it gas wont throttle up.adjusted high and low speed screws no luck. replaced fuel lines and filters.sounds like its ...

high speed idle to no avail. Have you replaced the fuel filter in the tank? it will idle as the engine is not calling for much fuel, however at full revs it calls for a greater amount of fuel, if that

chainsaw, I rebuilt the carb with all new everything. Now it will start with choke all the way out. Idles really high. If I push choke in, it dies instantly. The hi-lo and Idle is off I know for sure.

...high revs there are two adjusting screws on the crab one with a H and one L tightening the H one untill it stops then turn back one and a quarter turns start the engine rev the engine and adjust the ...

motor starts to die then anti-clockwise 3/4 turn. High speed is a little more difficult, On full revs wind clockwise till saw starts to rev out (lean Mixture) then back till the sound starts to bubble

revs too high.When screw cant acheive better revs,reset idle.Then,rev saw to max revs,adjusting H screw to get max revs,then when max revs acheived,turn screw anti clockwise 1/4 turn out.That gives it