Questions & Answers for: chainsaw leaking gas exhaust

...gas mixture. checked exhaust for restriction. any ideas? Does it seem to have about the same compression as the other? Does it have equal spark? Any excess friction when pulling it through? When you ...

...chainsaw...gas leaks from the gas cap past the rubber o-ring seal...dealer said to soak the o-ring in grease..I did...it still leaks...he said the mfg rubber rings all leak By MANY accounts,not the ...

...md.#302...help Try putting a new spark plug in it.Check your gas and oil mix.you might have too much oil in gas this will cause the oil to leak out the exhaust because it will not burn off the

won't start If it does not start its back to basics, drain the fuel tank anf fill with fresh fuel/oil mix, replace the fuel filter on the end of the hose in the fuel tank,check the condition of the ...

...leaking oil, there were a number of issues, one of which was the fit of the seals around the oil pump assembly, the inner and outer sealing was replaced by a single piece seal to make it better part ...

mccullach 1635 wont start. Spark is good, fuel is good but flooding and leaking through exhaust. carb issues... need to rebuild it or replace it

...leaking through the gas cap? And will that prevent it from starting? Also, does it really need (1998 model) need a 20:1 gas:oil ratio rather than the 40:1 on cap? The spark plug is good, I do get a ...

...chainsaw dies when I give it gas and I think the bar and chain oil is leaking out during storage. leaking chain and bar oil during storage and dies when I give it gas try and run it with the muffler ...

...chainsaw using a lot of gas? Check for leaks in fuel lines, carb,or tank. If none found is the exhaust VERY smokey? If so turn the H needle valve for High CW a bit at a time till the saw still ...

...Gas leaking could be an issue with a fuel pressure regulator. But the oil thru the exhaust seems like it could be issues with piston rings or rocker valves (like exhaust valve stuck open and oil ...