Questions & Answers for: chainsaw leak bar oil

bar must be flush on chainsaw body not on stud flange if bar is on stud flange there is a gap so oil leaks out near sprocket and not in bar oil channel I imagine that the oil tube and or drip hole for

...chainsaw bar bolt loose and leaking oil My Husqvarna 345 has been leaking bar oil. I was trying to figure out the problem and when I took off the bar the bar bolt fell back into the bar oil tank. I ...

chainsaw that is stored for long periods of time (weeks or even days) to leak out the bar oil. This is normal for chainsaws stored for several weeks or more. Some of it may be reduced by adjusting the

...time if its leaking out the bottom were the bar goes in too the chain saw this is normal this is the bar lube oil its thicker that regular oil and sticky U should have a screw plug marked lube for ...

...chainsaw dies when I give it gas and I think the bar and chain oil is leaking out during storage. leaking chain and bar oil during storage and dies when I give it gas try and run it with the muffler ...

...chainsaw leak because they are stored in a place with varying temperatures which causes the oil to expand and contact. You only notice it when the oil expands and leaks out the bar. Try and clean ...

...chainsaw body leaving a gap for oil to leak. If your bar is worn, most bars can be flipped over and used either way. If it is made to be used in on either side it will have a hole for the oil to get ...

...leak Poulan Chainsaw 3816. The bar oil comes out very fast and leaks out. I've taken off the bar, chain, and cover so after starting it up I can see the bar oil coming out of a hole. sounds like the ...

...chainsaw leaking bar oil Leaks bar oil It's quite common, if it's only leaking a little it's not really worth the trouble chasing the leak down. Your saw will have an online manual which may detail ...

...Chainsaw Bar Oil Leak Repair How To Remove Clutch I had the same problem with Poulan 1420 electric chainsaw. I open the saw and find out that the oil tank was cracked just below the push ...