Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...spark) and gas new spark plug and air filter and it wont start. Check to see if your ignition switch ( on& off) switch still have both wires attached. Common problem with that saw, loose or ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...chainsaw need 2-cycle oil mixed with the gas. Assuming you have the right oil-gas mixture and a fresh batch of gas, and you didn't leave old gas in the saw all summer long since last November. -Take ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...gas getting spark. was working fine I shut it off to load wood. When I tried to start it back up it wouldn't. Cleaned spark plug and air filter started but as soon as I gave it gas it shuts off did ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
husqvarna model 136 chainsaw that wont start.Has spark,gas compression trie with another spark plug if not heling check maybe air leak between cilinder and carb. also if not helpin rebuild carburattor
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...no shorts has spark and gas and will not hit if the chainsaw wont start check if the right fuel is in the tank it should take gas and oil mixed and see if if the choke is off while trying to start ...
Question about Pro 42CC 2 Cycle Chainsaw, 18"
...gas and oil. Has good spark but won't pop. Chainsaw won't start. Replaced carburetor, fuel lines, fuel filter, ignition module, spark plug. Using new gas and oil. Has good spark but ...
...Fairly new 455 rancher. Always started first pull. now not starting. pulled the plug and no gas getting to it. got spark, need gas! :-) needle valve could be stuck shut ,gas could be gumed up at
...out from the gas, if it is getting gas. I have answered how to check fuel problems and electrical problems. Look up the answers for chainsaw problems on Oct 1 and 2 or at my page. Hope this
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...chainsaw I have chained the plug,new gas still no start check the coil for if there is no spark it will never start.If you can't check the coil take the coil off,then take to a shop that can test it ...
...Chainsaw P3314 is flooding. Cylinder seems to have excessive Gas in it. What can be done for this? Also does not seem to want to start even after Carb has been cleaned and the Cylinder has been ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions