Questions & Answers for: chain slack

...slack out of my chain. Is this the procedure I must take to do so? Also, How much slack should a motorcycle chain have to it? 40mm slack up and down middle of chain. not tight when sitting on bike. ...

Ad

Question about Toilet Onepiece Ultramax MS854114SL.12

1 Answer

...slack in the chain. when the handle is at rest, there should be very little slack in the chain. and when you flush, don't slam the handle. also, if the handle is all the way down when you flush and ...

Ad

...chain back on check the slack in the chain if its too loose u will need tighten it up but if u cant tighten the chain up due to chain streched out then u may need to take a few links out of the ...

...slack in chain .tighten rear wheel.turn the rear wheel by hand and the chain get massive slack till you get to the point you started .please help let me know how to fix you need a new chain. the old ...

Question about 2004 YZ 450 F

1 Answer

...chain slack? Typical chain slack should be about two inches from bottom edge of the chain to the top. Grabbing the chain in the middle (halfway from sprocket to sprocket) and moving it up and down. ...

Question about 2003 VN 1500 Vulcan Meanstreak

1 Answer

...a certain point and the tensioner can no longer compensate for the slack, it must be replaced. Failure to replace a slack / worn chain can have severe consequenses, even if the chain does not

Question about 2002 TT-R 125

1 Answer

chain how much slack do I need While sitting on the bike, reach down and grab the chain in the center of the front and rear sprocket,lift the chain up and down, you should have 1inch to 2inch slack up

Question about 2005 Ninja 250 R

1 Answer

...chain slack. Your chain should not be too tight or too loose. If you grab your chain in the middle and push it up and down, you should have a slack measurement of 1 1/4 inches from the bottom edge of ...

...timing is still ok if the chain is slack.spluttering is usually a carburation issue or an ignition issue,loose camchains just make a noise until they get so loose that they jump teeth and bend

Question about 2005 Ninja 250 R

1 Answer

slack in chain. make sure the tension adjustment nut (usually square head) is in groove of bar. When chain is back on bar slide the bar forward taking up the slack. Put the cover back on, put the nuts

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Brad Brown

Level 3 Expert

19187 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66963 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...