Questions & Answers for: chain saw rev

...chain/bar size for my husqvarna Model 254 chainsaw This saw runs sluggishly when in hard timber. Not sure the size bar/chain are original. What is recommended? Maximum bar size of 20" but would ...

chain saw wont rev up my 18" poulan chain saw will start ok but it wont rev up.while i hold the triger on it runs but wont fev up.when i release the trigger it stalls.it will start back up.but runs at

...chain saw cuts out on high revs Many saws made today are using electronics for engine control. If the engine rpm's starts to rev to high, the electronics in the coil will start to 'cut out' some of ...

...saw dies.Almost act's like the chain brake is on but it is dissengaged.Both air-fuel mixture screws are adjusted correctly.Saw is a poulanpp4620avx.Saw will not rev fast enough to turn chain. ...

...chain saw has three screws to adjust. One is when you press the accelerator on the high revs. Then adjust the vividness of the saw. Another screw on the carburetor when the throttle is released and ...

...chain saw over reves and will stick seems your over rev's may be your carb is sucking air it could be the intake gasket isn't lined up properly or the carb mounting bolts vibrated lose sometimes the ...

...saw off can you move the chain by hand? When you rev the saw does it sound labored? The groove in the bar might be obstructed making the chain hang up. If it revs freely but the chain doesn't move, ...

...chain saw The saw starts but dies out under cut and it will not stay running while idling adjust the L screw in fully till right in,then out 1.5 turns,same with H screw.Then start saw,adjust L screw ...

...saw, if the chain is sharpened with an aggressive angle, the little pads start slipping are wear quickly. If you have the chain tension tightened too much, it will bind in the guidebar and stop the ...

...chain saw will not keep chain tight. you tighten chain rev. engine chain will just about come okk -tighten chain rev. engine same thing. you have to use the tension screw to move the cutter bar to ...